Skip to main content

KAKUTE F3

Target Hex code: SPRACINGF3

Description

MCU, Sensors and Features

Hardware

  • STM32F303CCT6(256kB flash) 32-bit processor
  • MPU6050 Gyro/Accelerometer
  • High quality, gold plated PCB
  • Micro USB connector for programming
  • Dimensions: 36x36x6mm (includes USB in height)
  • Mounting Holes: 30.5mm square to center of holes
  • Weight: 4.2g

Features

  • Recessed, sideways pin headers. Also enables soldering of all wires directly to pads without use of any pin headers.
  • Dedicated Boot button for easy firmware flashing.
  • Reinforced solder pads for trouble-free direct soldering.
  • Extremely low profile design.
  • Input voltage 7v to 42v. Power the board directly from flight pack up to 6S (on 'BAT' pad only!).
  • VIN + VBAT merged -A single wire to power the board will provide voltage input and Telemetry/OSD voltage data.
  • Filtered voltage output -output 5v 800mA (and 3.3v 150mA where applicable) to power peripherals such as GPS, RX, BLACKBOX, OSD. 5v/3.3v RX selectable.
  • Cleanflight support (RACE target).
  • BLHeli flashing supported by hardware
  • Raceflight ready
  • Betaflight ready

Kakute FC Betaflight additional features pad assignments

PAD ON Kakute FCFUNCTION
PPMSoftserial 1
LEDSoftserial 2

Softserial pad assignment can be enabled with the resource command. You can use these pads to connect to SmartAudio on a unify or telemetry on a tramp. Note: you must be using Betaflight 3.1.6 or later. In cli type these commands: resource ppm none resource serial_tx 11 a00 resource led 1 none resource serial_tx 12 A08 save

Manufacturers and Distributors

https://www.nextfpv.com.au/products/full-metal-racing-kakute-f3-flight-controller-v1-0

Manual

https://cdn.shopify.com/s/files/1/0412/2761/files/FMR_Kakute_Flight_Controller_Manual_v2.pdf?2155904968756041300

Maintainers

Similar Targets

Variants

Differences:

FAQ & Known Issues

Other Resources

Setup Guide:

Rcgroups Thread:

Image