Skip to main content


Aikon F4


FC with no PDB aimed at multi-rotor and fixed wing use, Aikon F4 features a carefully-chosen timer design which allowed to run 4-6 motors with burst DSHOT with maximum efficiency. On board are dedicated pads for ESC telemetry, VTX and camera control. Board also features an 11-pin connector for plug-and-play connection with Aikon AK32 4in1 ESC, providing voltage, current and ESC telemetry reading with no additional wires.

MCU, Sensors and Features


MCU: STM32F405 IMU: ICM-20602 Motor outputs: 4-6 IMU Interrupt: Yes BARO: Optionally VCP: Yes Hardware UARTS: UART1 for SerialRX, UART3 for Inverted SmartPort, UART2 and UART4 available for general use Software serial: SOFTSERIAL1 for VTX control (shared with UART1TX), SOFTSERIAL2 for ESC telemetry (shared with UART4RX) OSD: Yes Blackbox: SPI 16MB PPM/LED_STRIP Shared: Yes Battery Voltage Sensor: Yes Integrated Voltage Regulator: Yes Buttons: Boot Features

UART3 inverter is controllable by software, you can use the SBUS pad for any unidirectional protocol by setting serialrx_inverted accordingly. There's also a solder-jumper to bypass the inverter and connecto UART3_RX to DSMX pad directly.

Software serial is preconfigured by default, all you have to do is enable SOFTSERIAL1 for VTX control and SOFTSERIAL2 for ESC sensor on the Ports tab in Configurator.

Manufacturers and Distributors


AIKON Electronics Avi Jang


Andrey Mironov (@DieHertz)